Mike Shaw Subaru Greeley
2013 Subaru Brz Oil Filter
Subaru Oil Filter service at Mike Shaw Subaru Greeley in Greeley, CO
SCHEDULE NOWFrequently asked questionsFrequently Asked Questions
6 common questions answered
Is the oil filter replaced every time a 2013 Subaru BRZ has its oil changed?Yes, the oil filter should be replaced with the oil during this service.
The filter captures debris carried by engine oil and can become loaded as it works. Once loaded, its bypass valve opens, allowing oil to circulate without filtration. Replacing the filter with the oil helps maintain filtered oil flow rather than carrying an old filter into another change.
- Filter matched to the 2.0-liter engine
- New drain plug gasket or washer where applicable
- Leak check after the engine runs
What is included in an oil filter replacement on a 2013 Subaru BRZ?The service includes an engine-matched filter, a new drain plug gasket or washer where used, and a post-service leak check.
The filter is selected for the 1,998 cc flat-four engine actually fitted to the vehicle. After installation and the oil change, the engine is run so the filter seal can be checked under operating conditions. This confirms the service area remains dry after the work.
- Filter matched to the engine's specification
- Replacement sealing component where the engine uses one
- Inspection for leaks at the filter seal
What happens if the oil filter on a 2013 Subaru BRZ is not replaced?A loaded filter can open its bypass valve, allowing oil to circulate without being filtered.
The engine can still receive oil, but it may no longer receive oil cleaned of the debris the filter has collected. This is a quiet loss of filtration rather than an immediate stop in lubrication. An oil-pressure warning, unusual engine noise, or oil that darkens quickly after a change warrants attention.
- Debris remains captured in an aging filter
- The bypass valve may open as the filter loads
- Unfiltered oil may circulate through the engine
Does a 2013 Subaru BRZ need a specific oil filter?Yes, the filter is matched to this engine, and filters are not interchangeable across engines.
The 2013 Subaru BRZ has a 1,998 cc, 2.0-liter flat-four engine, so the replacement filter must match the engine's requirements. The correct filter is selected for the engine actually fitted rather than assuming one filter works for every vehicle. The service also includes checking the filter seal after the engine runs.
- 2.0-liter engine application
- Four-cylinder flat-four layout
- Filter matched to the fitted engine
Can the oil be changed on a 2013 Subaru BRZ without changing the filter?The oil can be changed separately, but the filter should be replaced with the oil during this service.
The filter holds debris removed from the engine oil and may open its bypass valve after loading. Reusing it across another oil change can allow unfiltered oil to circulate. The manufacturer's schedule and the vehicle's service history help determine broader maintenance planning, while this service pairs the new filter with the oil.
- Debris captured by the existing filter
- Bypass valve operation when the filter loads
- New filter installed with the oil
How do I book an oil and filter service at Mike Shaw Subaru Greeley?You can schedule an appointment online or call Mike Shaw Subaru Greeley at 970-373-0692.
The dealership is located at 4720 W 24th St in Greeley, CO 80634. Booking the service gets a filter matched to the engine actually fitted and replaced alongside the oil, followed by a leak check after the engine runs. You can also review the dealership's service specials before booking.
- Online service appointment scheduling
- Phone support at 970-373-0692
- Service location in West Greeley
