2017 Subaru WRX Alignment: Specs & Service

An alignment check is also useful when the vehicle pulls on a flat road, the steering wheel is off center, or the tires wear unevenly. It should be considered after suspension work or a major pothole impact because either event can change wheel angles. Mike Shaw Subaru Greeley can measure the current angles against factory specifications before recommending an adjustment.

• Steering and suspension inspection every 12,000 miles
• Camber, caster, and toe measured on all four wheels
• Adjustment performed where the suspension allows

These symptoms can occur when the wheels are no longer aligned with the manufacturer's specifications. Misaligned wheels scrub the tires as the vehicle rolls, which can create uneven tread wear. A vibration at speed can also justify an inspection, although the underlying cause should be diagnosed rather than assumed to be alignment-related.

• Vehicle pulls on a flat road
• Steering wheel sits off center while driving straight
• One edge of a tire wears faster than the other

The service begins with an inspection of the tires, steering, and suspension for wear that could hold the alignment out of specification. Measuring the current angles helps determine whether adjustment is needed before work is performed. This approach gives the driver a clearer answer about the vehicle's condition instead of assuming an adjustment is necessary.

• Camber, caster, and toe measurement
• Inspection of tires, steering, and suspension components
• Adjustment toward factory specification where the suspension allows

The inspection should look for wear in components that influence wheel position and steering response. If a component is worn, adjusting the angles alone may not correct the concern for long. Mike Shaw Subaru Greeley can identify conditions affecting alignment and explain whether adjustment is appropriate before additional work is recommended.

• Inspect steering components for wear
• Inspect suspension components that can affect wheel angles
• Confirm whether the suspension allows adjustment to specification

A vehicle that tracks straight may not need an adjustment at every tire rotation. However, measuring the angles can confirm whether they remain within the manufacturer's specifications. The inspection also checks for tire, steering, and suspension wear that may affect alignment results.

• Check for uneven tire wear
• Measure all four wheel angles
• Inspect components that could prevent alignment from holding

These measurements show how each wheel is positioned relative to the vehicle and the road. The results are compared with the manufacturer's specifications, and adjustment is made where the suspension allows. The process also includes checking the tires, steering, and suspension for wear that could influence the readings or cause the vehicle to move out of alignment again.

• Camber measurement
• Caster measurement
• Toe measurement on all four wheels

Before adjustment, the tires, steering, and suspension components should be inspected. Wear in these areas can hold an alignment out of specification or prevent the vehicle from maintaining the corrected angles. Drivers may notice a pull on a flat road, an off-center steering wheel, uneven wear on one tire edge, or vibration at speed. Measuring first helps distinguish an alignment concern from a component condition that needs attention.

The 2017 Subaru WRX uses standard all-wheel drive, so checking all four wheels supports consistent handling and tire contact. Bring your 2017 Subaru WRX to Mike Shaw Subaru Greeley in Greeley for a factory-spec alignment — schedule service.

Alignment work covers camber, caster, and toe on all four wheels, along with inspection of the tires, steering, and suspension. These checks matter because worn components can affect the readings and may prevent the alignment from holding. Comparing the measured angles with the manufacturer's specifications helps keep the recommendation focused on the vehicle's actual condition.

To discuss an alignment concern or arrange an appointment, visit Mike Shaw Subaru Greeley in Greeley. Schedule service online or call 970-373-0692 for directions and appointment assistance.